Brother CP1800 Service Manual download pdf (Page 31)

III - 13

Removing the sub cover and control panel PCB

(2) Take off the sub cover by removing the screw.

(3) Disconnect the panel harness from the main PCB.

Only when you need to replace the panel cover or control panel PCB, perform steps (4) through

(6).

(4) Peel off the panel sheet.

NOTE: Once removed, the panel sheet will become unusable and a new one will have to be

put back in.

(5) Remove two screws from the panel cover. Push up the front face of the panel cover to

release its latches and pull it towards you.

(6) Remove the two screws from the control panel PCB.

nn Reassembling notes

• When securing the panel cover with screws, press it in the direction of arrows "A" and "B" as

shown below.

• When securing the sub cover with a screw, press it in the direction of arrows • through ƒ as

shown below.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

No comments

Brother CP1800 Service Manual Page 31