Brother HL-4570CDWT User's Guide download pdf (Page 189)

Appendix

183

Bar code, expanded character, line block drawing and box drawing offset in X-axis A

n = ‘xnnn’ or ‘Xnnn’

This parameter shows the offset from the left margin in the ‘u’- or ‘U’-specified unit.

Bar code & expanded character offset in Y-axis A

n = ‘ynnn’ or ‘Ynnn’

This parameter shows the downward offset from the current print position in the ‘u’- or ‘U’-specified unit.

Bar code, expanded character, line block drawing and box drawing height A

n = ‘hnnn’, ‘Hnnn’, ‘dnnn’, or ‘Dnnn’

1 EAN13, EAN8, UPC-A, ISBN (EAN13, EAN8, UPC-A), ISBN (UPC-E): 22 mm

2UPC-E: 18mm

3 Others: 12 mm

Expanded characters i 2.2 mm (preset)

Line block drawing and box drawing i 1 dot

This parameter shows the height of bar codes or expanded characters as shown above. It can start with ‘h’,

‘H’, ‘d’, or ‘D’. The height of bar codes is shown in the ‘u’- or ‘U’-specified unit. The default setting of the bar

code height (12 mm, 18 mm or 22 mm) is determined by the bar code mode selected by ‘t’ or ‘T’.

Expanded character width, line block drawing and box drawing A

n = ‘wnnn’ or ‘Wnnn’

Expanded character i 1.2 mm

Line block drawing and box drawing i 1 dot

This parameter shows the width of expanded characters as shown above.

Expanded character rotation A

Bar code data start A

n = ‘b’ or ‘B’

Data that follows ‘b’ or ‘B’ is read in as bar code data. Bar code data must end with the ‘ \ ’ code (5CH), which

also ends this command. The acceptable bar code data is determined by the bar code mode selected by ‘t’

or ‘T’.

n = ‘a0’ or ‘A0’ ‘Upright (preset)

n = ‘a1’ or ‘A1’ ‘Rotated 90 degrees

n = ‘a2’ or ‘A2’ ‘Upside down, rotated 180 degrees

n = ‘a3’ or ‘A3’ ‘Rotated 270 degrees

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 198 199

No comments

Brother HL-4570CDWT User's Guide Page 189