Brother HL-760 Series User Manual download pdf (Page 41)

CHAPTER 4 OPTIONS

CHAPTER 4 –7

✒ Note

The printer has only one slot for a SIMM upgrade. If you want to increase

your printer memory again after you have installed a SIMM module into

the slot, you will need to remove the previously installed SIMM first. For

example if you have previously increased your memory form the standard

1MB to 3MB by adding a 2MB SIMM and you wish to increase your total

memory to 5 MB, you need to remove the installed 2MB SIMM and install

the new 4MB SIMM into the printer.

Installing the SIMM

To install the SIMM, follow these steps:

1. Turn off the power switch and unplug the power cord from the AC

outlet. Disconnect the interface cable (printer cable) from the printer.

Fig.

4-3

Unplug the Power Cord

and Disconnect the Interface Cable

Caution

Be sure to turn off the power switch and unplug the power cord to the

printer before installing or removing the SIMM to/from the main controller

board.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 80 81

No comments

Brother HL-760 Series User Manual Page 41