Brother BE-1201B-AC-PC User Manual download pdf (Page 22)

1-4 BE-0901E-AC-PC• BE-1201B-AC-PC

Chapter 1 An Introduction of Embroidery Machine

2. Software

2-1 Necessary Systems

The following systems are needed for installing the software.

• Personal computer with a CPU of Intel Pentium 166 MHz or above

(Even if the software is operable under the environment less than the required specification, such a

case is out of the scope of warranty.)

• Memory of 32 MB or above (Even if the software is operable under the environment less than the

required specification, such a case is out of the scope of warranty.)

• Free space of 100 MB or above in the hard disk

• 3.5 floppy disk drive

• CD-ROM drive

• Video card of 1024 × 768 resolution in 256 colors

(1280 × 1024 in 65000 colors is recommended.)

• Serial port (RS-232C) × 1

• PCI slot x 1

Use the full-size type. Any low-profile type PCI or half-pitch type PCI cannot be used.

In the PCI slot, an interface board (option) shown in the photo below is installed.

W1691

• Windows 95/98/2000/NT4.0/XP (Some functions are not available with Windows NT. Refer to page

4-18.)

• Non-DOS data such as Barudan FDR is not supported to do input and output of data in case of FDD

using USB.

Full-size type PCI

Board dimension 106.68mm

Bracket dimension 120mm

t dim

Board dimension

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 245 246

No comments

Brother BE-1201B-AC-PC User Manual Page 22