Brother HL-2600CN Series User's Guide Page 137
- Page / 225
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
CHAPTER 5 MAINTENANCE
5-25
!
Caution
When removing the Fusing Unit from the printer, be sure to keep the Fusing
Unit flat, so oil will not spill. Considerable damage can occur if oil is spilled
inside the printer.
5.
Remove the Oil Bottle and the Fuser Cleaner from the Fusing Unit.
6.
Install the new Fusing Unit into
the printer. Be sure to insert the
Fusing Unit completely into the
printer.
Fig. 5-22
7.
Secure the Fusing Unit with the
two long screws.
Fig. 5-23
8.
Install the Fuser Cleaner and the Oil Bottle into the new Fusing Unit, and
then lock the Oil Bottle Lock Levers. Be careful not to spill oil inside the
printer. This could damage the printer.
9.
Close the Top Cover.
10.
Plug the printer into the AC outlet.
- (For USA & CANADA Only) 3
- INTERNET ADDRESS 3
- CHAPTER 1 INTRODUCTION 7
- TABLE OF CONTENTS 8
- CHAPTER 5 MAINTENANCE 9
- CHAPTER 6 TROUBLESHOOTING 9
- APPENDIX 10
- REGULATIONS 11
- International 12
- Compliance Statement 12
- Laser Notices 13
- Safety Information 15
- CHAPTER 1 INTRODUCTION 17
- 2400 DPI Class Resolution 23
- High Resolution Control (HRC) 23
- Universal Paper Cassette 24
- Three Interfaces 24
- Automatic Interface Selection 24
- Five Emulation Modes 25
- Automatic Emulation Selection 25
- Data Compression Technology 25
- Panel Lock Function 26
- Power Save Mode 27
- Toner Save Mode 27
- Reprint Function 27
- PANTONE 28
- Calibrated 28
- Paper Handling 29
- Hard Disk Drive (HD-6G/HD-EX) 29
- RAM Expansion 30
- Power Supply 30
- Environment 31
- 20cm(8") 32
- 70cm(28") 32
- 50cm(20")50cm(20") 32
- CHAPTER 2 DRIVER AND SOFTWARE 33
- Basic Tab 35
- Advanced Tab 36
- Print Quality 37
- Duplex 38
- Watermark 38
- Page Setup 38
- Device Options 39
- Job Spooling 40
- Accessories Tab 41
- Support Tab 42
- Details Tab 43
- Paper Tab 44
- Graphics Tab 45
- Device Options Tab 46
- BRAdmin Professional 48
- Storage Manager 48
- Analysis Tool Software 48
- Driver Deployment Wizard 49
- Apple LaserWriter 8 Driver 51
- For Network users* 52
- EPSON (Default) IBM 56
- Paper Size 59
- Paper Source 62
- Available Size and Paper 62
- Capacity 62
- Recommended Paper 63
- Printable Area 64
- Envelopes 65
- Direction 66
- Fig. 4-1 70
- Reprinting the Last JOB 75
- Printing PROOF Data 77
- Printing PUBLIC Data 78
- Printing SECURE Data 79
- To delete the job 81
- To cancel the reprint job 81
- To set numbers 82
- READY LED 84
- POWER LED 84
- ALARM LED 84
- DATA LED 84
- Printer Status messages 87
- INFORMATION 91
- SETUP (Continued) 94
- PRINT MENU 95
- PRINT MENU (Continued) 96
- NETWORK (Network Users Only) 100
- INTERFACE 101
- RESET MENU 102
- Set Date and time 103
- Set IP Address 104
- About Emulation Modes 105
- HP-GL Mode 106
- List of Factory Settings 107
- CHAPTER 5 MAINTENANCE 112
- Toner Nearly Empty Message 117
- Toner Empty Message 117
- 120
- Oil Bottle Low Message 121
- Oil Bottle Empty Message 121
- Replacing the Oil Bottle 123
- Fig. 5-7 124
- Fuser Cleaner Message 125
- Fuser Cleaner Change Message 125
- Replacing the Fuser Cleaner 126
- Take the Fuser Cleaner out of 127
- Waste Toner Pack Full Message 128
- Open the Front Cover 129
- Remove the Waste Toner Pack 129
- OPC Belt Cartridge Message 130
- Fig. 5-13 131
- Remove the OPC Belt 131
- Cartridge from the printer 131
- Fig. 5-14 131
- Remove the Tension Release 132
- OPC Belt Cartridge 132
- Ozone Filter 134
- Replacing the Ozone Filter 134
- Fusing Unit 135
- Replacing the Fusing Unit 136
- Close the Top Cover 137
- Caution, Warning 138
- 120K Kit 139
- Drum Cleaner 140
- Replacing the Drum Cleaner 140
- Fig. 5-26 141
- Paper Discharger 142
- Clean the area where the new 143
- Paper Discharger is to be 143
- Replacing the Transfer Roller 144
- Cleaning the Printer Exterior 147
- Periodic Printer Cleaning 148
- Open the Rear Access Cover 149
- Do not break the Corona Wire 150
- Close the Rear Access Cover 150
- Fig. 5-46 152
- Fig. 5-47 152
- How to Repack the Printer 156
- Duplex Unit 164
- Tray Unit 165
- Open the Duplex Cover Top 166
- Assembly and remove the 166
- Duplex Cover Top Assembly 166
- Lower Tray Unit 167
- Selecting the Optional Fonts 168
- Font Numbe 170
- Fig. 5-78 171
- Fig. 5-81 172
- Connect the flat cable to the 173
- CHAPTER 6 TOURBLE SHOOTING 178
- Error Message Remarks 179
- Error Message Meaning Action 182
- Call Service 183
- Meaning Action 183
- Service Call 184
- Paper Jam 186
- CHAPTER 6 TROUBLE SHOOTING 187
- PAPER JAM AT PAPER EXIT 188
- Fig. 6-4 190
- Fig. 6-5 191
- Fig. 6-6 191
- CHAPTER 6 TROUBLE SHOOTING 192
- Fig. 6-9 193
- Fig. 6-10 194
- DUPLEX UNIT 195
- Question 196
- Recommendation 196
- Question Recommendation 200
- 10°C (50°F) 201
- Service Representative 204
- Paper Types to Avoid 211
- ENVELOPES 212
- ISO 2 IRV 216
Related products and manuals for Print & Scan Brother HL-2600CN Series
Print & Scan Brother MFC-9560CDW User Manual
(229 pages)
(229 pages)
Print & Scan Brother MFC-7840W User's Guide
(151 pages)
(151 pages)
Print & Scan Brother HL-5350DN Setup Guide
(25 pages)
(25 pages)
Print & Scan Brother DCP-9040CN User Manual
(161 pages)
(161 pages)
Print & Scan Brother AX-430 User Manual
(61 pages)
(61 pages)
Print & Scan Brother PT-200 User Manual
(2 pages)
(2 pages)
Print & Scan Brother HL-1800 User Manual
(204 pages)
(204 pages)
Print & Scan Brother MFC-5490CN User's Guide
(199 pages)
(199 pages)
Print & Scan Brother HL-760 User Manual
(81 pages)
(81 pages)
© 2020, manymanuals.com. All rights reserved. | 0.055 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals