Brother MFC-J265W User's Guide download pdf (Page 43)

Telephone and external devices

35

6

Using a cordless external

telephone 6

Once the base unit of the cordless telephone

has been connected to the same telephone

line as the machine (see External and

extension telephones on page 33), it is easier

to answer calls during the Ring Delay if you

carry the cordless handset around with you.

If you let the machine answer first, you will

have to go to the machine so you can press

Tel/R to send the call to the cordless handset.

Using remote codes 6

Remote Activation code 6

If you answer a fax call on an extension or

external telephone, you can tell your machine

to receive it by dialling the Remote Activation

Code l 51. Wait for the chirping sounds then

replace the handset. (See Fax Detect

on page 28.)

If you answer a fax call at the external

telephone, you can make the machine

receive the fax by pressing Mono Start and

choose Receive.

Remote Deactivation Code 6

If you receive a voice call and the machine is

in F/T mode, it will start to sound the F/T Ring

(fast double-ring), after the initial ring delay. If

you pick up the call on an extension

telephone you can turn the F/T Ring off by

pressing #51 (make sure you press this

between the rings).

If the machine answers a voice call and fast

double-rings for you to take over, you can

take the call at the external telephone by

pressing Tel/R.

Changing the remote codes 6

If you want to use Remote Activation, you

have to turn on the remote codes. The preset

Remote Activation Code is l 51. The preset

Remote Deactivation Code is #51. If you

want to, you can replace them with your own

codes.

a Press Menu.

b Press a or b to choose Fax.

Press OK.

c Press a or b to choose

Setup Receive.

Press OK.

d Press a or b to choose Remote Codes.

Press OK.

e Press a or b to choose On (or Off).

Press OK.

f Enter the new Remote Activation Code.

Press OK.

g Enter the new Remote Deactivation

Code.

Press OK.

h Press Stop/Exit.

Note

• If you are always disconnected when

accessing your external TAD remotely, try

changing the Remote Activation Code and

Remote Deactivation Code to another

three-digit code using the numbers 0-9, l,

#.

• Remote Codes might not work with some

telephone systems.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 114 115

Comments to this Manuals

No comments