Brother CX155LA Use and Care Manual download pdf (Page 43)

——

——————————————————————————————————————————————————————————————————————————————————————————————————————————————————————

Starting to sew

Raise the needle by turning the handwheel

toward you (counterclockwise) so that the mark

on the wheel points up. (With models equipped

with (needle position button), raise the

needle by pressing once or twice.)

Raise the presser foot lever.

a Presser foot lever

Place the fabric under the presser foot, pass

the thread under the presser foot, and then

pull out about 5 cm (2 inches) of thread

toward the rear of the machine.

a 5 cm (2 inches)

While holding the end of the thread and the

fabric with your left hand, turn the handwheel

toward you (counterclockwise) with your

right hand to lower the needle to the starting

point of the stitching.

Lower the presser foot lever.

a Presser foot lever

On models equipped with a sewing speed

controller, slide the sewing speed controller

to the left or right to adjust the sewing speed.

Refer to “Sewing speed controller (for models

equipped with the start/stop button)”

(page 15).

a Sewing speed controller

Slowly press down on the foot controller.

(With models equipped with (start/stop

button), if the foot controller is not connected,

press once.)

aStart/stop button

X The machine starts sewing.

a Mark b Needle position button

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 115 116

No comments

Brother CX155LA Use and Care Manual Page 43