Brother Innov-is VM6200D User Manual download pdf

Before start sewing, test the pattern first from steps

a to e to see if the stitch can be used with this

function. Before starting to sew, mark the end

point.

Turn on the machine.

Press the Utility or Character Decorative

Stitch tab on the Utility Stitch Screen.

Start sewing, and then stop the machine

when the desired sewing end point enters

the sensor pen touch range.

Press .

→ The sensor functions screen appears.

Press .

→ The sewing end point setting screen appears.

Using the Sensor Pen to Specify the Sewing End Point

(Version 1.05 or later)

The procedures to specify the sewing end point using the sensor pen differ from

those described in the Operation Manual. Refer to the following.

We recommend that you keep this manual with the Operation Manual.

Note

• In order to specify the location accurately, use the sensor pen to touch the end point twice. Be sure to

touch the same point.

• Before starting to sew, mark the end point.

Note

• If the needle drop point is being specified

with the sensor pen within 70 mm (approx.

2-3/4 inches) from the sewing end point, the

machine will not require the second touch.

After completing step

f, continue with

step

j. However, the actual sewing end

point may be slightly different than the

specified location.

In order to specify the location accurately,

stop the machine at a location more than

70 mm (approx. 2-3/4 inches) away from

the sewing end point before specifying it for

the first time.

Memo

• If the needle drop point is greater than

100 mm (approx. 4 inches) from the

selected ending point using the sensor pen,

a more accurate position can be specified

the second time that the point is touched.

Note

• If is not available, the sewing end

point cannot be specified with the selected

stitch pattern. Select a different stitch

pattern.

1 2 3 4

Summary of Contents

Page 1 - (Version 1.05 or later)

1Before start sewing, test the pattern first from steps a to e to see if the stitch can be used with this function. Before starting to sew, mark the e

Page 2 - Touch once Touch twice

2fWith the sensor pen, touch the location to be specified as the sewing end point.→ The distance from the current needle position to the touched locat

Page 3

3Stitch End Mode KeygPress , and then continue sewing.* The setting can also be applied by long touching an adjustment area with the sensor pen.→ Wh

Page 4 - to duplicate the previous

4 Reusing the Previous SettingWhen using the same fabric and pattern to sew the same length, the previous setting can be used again, instead of using