Brother LS-30 User Manual download pdf

Filling the bobbin

Place the thread spool on the spool pin and pass the

thread around the bobbin winder thread guide.

Pass the thread through

the hole on the bobbin

from inside, and slide the

winding shaft to the right.

While holding the end of

the thread, depress the

foot controller.

When the bobbin is full, it

will stop winding.

Cut the thread, slide the

winding shaft to the left

and remove the bobbin.

Hold the bobbin case as

shown, insert the bobbin

with the thread coming

from the bottom toward

the top and the thread tail

hanging out of the bobbin

case.

Pull the thread tail into the bobbin

case groove, under the spring clip

and into the thread guide hole.

Holding the bobbin case

by the latch align the ﬁnger

with the top opening of

the shuttle race , insert

the case into the shuttle

race and release the latch.

The latch should hold the

bobbin case in place.

Raise the needle to its

highest position and

remove the bobbin case by

pulling the latch.

Threading the needle

Raise the presser foot lifter.

Raise the thread take-

up lever to its highest

position by turning the

balance hand wheel.

Pass the thread through the thread guide and down the right

channel on the front of the machine.

Place the thread spool

on the spool pin.

Pass the thread into the thread tension discs or *behind the

thread tension dial from the right to the left.

Grasp the thread on both

sides of the tension disc

and pull to ensure it is in

place.

Guide the thread up the left channel, clear to the back of the opening

around the take-up lever and back down the left side of the channel to

thread the take-up lever.

Thread the needle from

front to back and pull out

about 2” of thread.

Thread tension

Upper thread tension is too tight.

(Locks appear on the surface of the fabric.)

Decrease the tension by turning the dial to a lower number.

Upper tension is too loose.

(Locks appear on the reverse side of the fabric.)

Increase the tension by turning the dial a higher number.

∗If these actions do not correct the problem, please rethread the machine using step A and B.

Correct thread tension

1 2

Summary of Contents

Page 1 - Thread tension

AFilling the bobbinPlace the thread spool on the spool pin and pass the thread around the bobbin winder thread guide.Pass the thread through the hole

Page 2 - ***READ ME FIRST***

DCleaning bobbin caseRaise the needle to its highest position, pull the latch and remove the bobbin case.CAUTIONTroubleshootingRemove the power plug f

Comments to this Manuals

No comments

Brother LS-30 User Manual

Browse online or download User Manual for Sewing machines Brother LS-30. Brother LS-30 User Manual [en]

Summary of Contents

Comments to this Manuals

Related products and manuals for Sewing machines Brother LS-30