Brother PC-210 Instruction Manual download pdf (Page 36)

GETTING READY ——————————————————————————————————————————————————

—

Place a different presser foot below the holder

so that the presser foot pin is aligned with the

notch in the holder.

Position the presser foot so the letter indicating

the presser foot type (A, G, I, J, M, N or R) is

positioned to be read.

1 Presser foot holder

2 Notch

3 Pin

Slowly lower the presser foot lever so that the

presser foot pin snaps into the notch in the

presser foot holder.

1 Presser foot lever

X The presser foot is attached.

Raise the presser foot lever to check that the

presser foot is securely attached.

Note

● For details on the presser foot that should be

used with the selected stitch, refer to “Stitch

Settings” (page 92).

Adjusting the pressure of

the presser foot

The amount of pressure that the presser foot applies

to the fabric can be adjusted.

Lower the presser foot lever.

1 Presser foot lever

Turn the presser foot dial at the back of the

sewing machine.

The scale on the dial indicates the range from

1 (weak) to 4 (strong). Turn the dial to the right

(smaller number) to decrease the pressure.

Turn the dial to the left (large number) to

increase the pressure.

When you are finished sewing, reset the dial

to 3 (standard).

Weak

Strong

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 110 111

No comments

Brother PC-210 Instruction Manual Page 36