Brother PE 150 User Manual download pdf (Page 28)

CONTENTS

MACHINE

KNOWLEDGE

EMBROIDERING MAINTENANCE

ERROR

MESSAGE

TROUBLESHOOTING

PATTERNS

EMBROIDERING

USING A SMALL

FRAME

(OPTIONAL)

EMBROIDERING

USING A

EXTRA-SMALL

FRAME (OPTIONAL)

EMBROIDERING

USING A LARGE

FRAME

(OPTIONAL)

CHANGING THE NEEDLE

Set the needle securely.

Checking for a bent needle

1 Place the needle on a flat surface and check

whether the space is parallel or not.

2 Flat surface

(Needle-plate, glass, ruler etc.)

If the space is not parallel then the needle is

bent and should be thrown away to prevent

damage to your project or the machine.

4. Insert the new needle into the needle shaft as

far up as it will go with the flat side of the

needle facing away from you. Secure it by

firmly tightening the screw with a screwdriver.

5. Turn the power switch on.

2. Loosen the needle screw with a screwdriver.

3. Slide the needle out.

1. Turn the power switch off and lower the

presser foot lever.

Turn the balance wheel to raise the needle to

its highest position.

1 “BASIC OPERATION” key

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 145 146

No comments

Brother PE 150 User Manual Page 28