BROTHER®HL-5200 • TN550 • 580TONER CARTRIDGE REMANUFACTURING INSTRUCTIONSBROTHER®HL-5200 SERIES • TN550 • 580 TONER CARTRIDGE(TN3145 • 3185 EUROPE)© 2
18. Set the reset gear and spring as shown. The straight tail of the spring fits into a notch at the base of the gear shaft.The teeth of the reset gea
21. Fill the cartridge with Brother 5200 black toner. 22. Replace the fill plug.Wipe the cartridge down to remove any remaining toner dust.23. Install
TEST PAGESHL-5240/5250 only:1. To print a test page from these machines, first turn the machine off.2. Press and hold the GO button and turn the print
COMMON TONER CARTRIDGE PROBLEMSAs some problems can be caused by both the toner cartridge as well as the drum cartridge, we have listed both here:Back
Released in November 2005, the Brother HL-5200 printer engine is based on a new 30ppm, true 1200 DPI laser engine. Whilethese cartridges are similar t
The cleaning section of the drum cartridge consists of a "cleaning brush" and a recovery blade. The cleaning brush has twoopposite charges p
1. Vacuum the exterior of the cartridge. Remove the fill plugfrom the toner cartridge. Dump the remaining toner andvacuum/blow out the cartridge. Make
5. The black spring-loaded reset gear may fall off as the plateis removed. This gear resets the printer when the cartridge isinstalled. New starter ca
9. Remove the non-gear side end cap by gently prying it off.10. On the gear side of the developer roller, press in on the locking tab and rotate the d
11. Remove the developer roller. 12. Vacuum the doctor blade and foam feed roller clean. Wedo not recommend that the doctor blade be removed and thede
14. Clean the developer roller with a lint free cloth. Do not use any chemicals other than a dedicated cleaner for the Brother rollersto clean the rol
16. Clean the gears, making sure that they have no toner onthem. This is a good time to also check the gear shafts tomake sure there is enough grease.
Comments to this Manuals