Brother HL-3260N User's Guide download pdf (Page 270)

Appendix–28

Expanded Character Rotation

n = “a0” or “A1” Upright (default)

n = “a1” or “A1” Rotated 90 degrees

n = “a2” or “A2” Upside down, rotated 180 degrees

n = “a3” or “A3” Rotated 270 degrees

Bar Code Data Start

n = “b” or “B”

Data that follows “b” or “B” is read in as bar code data. Bar code data must

end with the “ \ ” code (5CH), which also terminates this command. The

acceptable bar code data is subject to the bar code mode selected by “t” or

“T”.

• When CODE 39 is selected with the parameter “t0” or “T0”:

Forty three characters “0” to “9”, “A” to “Z”, “-”, “ . ”, “ (space)”, “$”, “ / ”, “+”,

and “%” can be accepted as bar code data. Other characters cause data

error. The number of characters for bar codes is not limited. The bar code

data automatically starts and ends with an asterisk “ * ” (start character and

stop character). If the received data has an asterisk “ * ” at its beginning or

end, the asterisk is regarded as a start character or stop character.

• When Interleaved 2 of 5 is selected with the parameter “t1” or “T1”:

Ten numerical characters “0” to “9” can be accepted as bar code data. Other

characters cause data error. The number of characters for bar codes is not

limited. Since this mode of bar codes require even characters, if the bar

code data has odd characters, the zero character “0” is automatically added

to the end of the bar code data.

• When FIM (US-Post Net) is selected with the parameter “t3” or “T3”:

Characters “A” to “D” are valid and 1 digit of data can be printed. Uppercase

and lowercase alphabet characters can be accepted.

• When Post Net (US-Post Net) is selected with the parameter “t4” or “T4”:

Characters “0” to “9” can be data and it must be terminated by a check digit.

“?” can be used in place of the check digit.

1 2 ... 265 266 267 268 269 270 271 272 273 274 275 276

No comments

Brother HL-3260N User's Guide Page 270