Brother PC-3000 Instruction Manual download pdf (Page 51)

BAR TACKING

1. Measure the area to be bar tacked and set the length using

the scale on presser foot “A”. Pull on the end of the button

holder plate to expand it. The finished size of the bar tack will

be the space shown in the illustration.

1 Button holder plate

2 Scale on the presser foot

3 0.5 cm (13/64")

4 Length of bar tack

* 0.5 to 3 cm (13/64" to 1-13/64") is suitable for bar tacking. 0.5

to 1 cm (13/64" to 25/64") is the normal size.

2. Position the pocket as illustrated with the top of the pocket

facing you. Align the needle drop point with the corner of the

pocket to be stitched and move the pocket back 2 mm (5/64")

as shown below.

* After the presser foot lever has been lowered, adjust the

presser foot so that there is no gap behind the section that is

shaded in the illustration at the right. Otherwise,

the size of the stitch will not be correct. To adjust

the presser foot, push the presser foot towards

the back of the machine as shown in the figure at

the left.

* Pass the thread underneath the presser foot.

3. Check the first needle drop point, then lower the presser foot.

1 2 mm (5/64")

4. Lower the buttonhole lever and position it behind the metal

bracket on the buttonhole foot.

1 Metal bracket on buttonhole foot

For reinforcing the openings of pockets, etc.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 103 104

No comments

Brother PC-3000 Instruction Manual Page 51