Brother DCP-J132W Setup Guide download pdf (Page 5)

e Gently put the paper into the paper tray print

side down and top edge first. Check that the

paper is flat in the tray.

f Gently adjust the paper width guides to the

paper with both hands. Make sure that the

paper width guides touch the edges of the

paper.

g Close the output paper tray cover.

h Slowly push the paper tray completely into the

machine.

i While holding the paper tray in place, pull out

the paper support a until it clicks, and then

unfold the paper support flap b.

Check the print quality

a When the preparation process has finished, the

LCD shows this message

Set Paper and

Press Start

Press Colour Start.

b Check the quality of the four colour blocks on

the sheet. (black/yellow/cyan/magenta)

c If all lines are clear and visible, press a (Yes) to

finish the quality check and go to the next step.

If lines are missing, press b (No) and follow the

steps on the LCD.

IMPORTANT

Be careful that you do not push the paper in too

far; it may lift at the back of the tray and cause

paper feed problems.

Poor

1 2 3 4 5 6 7 8 9 10 ... 29 30

No comments

Brother DCP-J132W Setup Guide Page 5