Brother HL-630 User Manual download pdf (Page 31)

D:SERVICELINEAT

Xerox DC 220 Xerox Cartrid2e part # 113R120/113R178/113R276

OEM Stated Yield: 20,000

To reset the counter in the DC 220/230/240 OPC cartridges the connector on

the rear of the cartridge must be replaced. This will clear the 11 or 17

codes. 11 = Toner Out, 17 = Change cartridge

There are many different cartridges that use different connectors/chips for

these machines. A list of them is as follows:

DC220/230/420 Type A: 113R120, 113R178, 113R276DC220/230/420 Type B: 113RI79,

113R275

DC220/230/420 Type C: 113R313 DC332/340 Type A: 113R315, l13R317 DC332/340

Type B: 113R316

Each cartridge type is for a different machine. When ordering the replacement

chip, make sure you know

he correct cartridge part number that your

customer's machine calls for. The chips are not interchangeable.

ther

cartridges error codes are:

J 6: Incorrect cartridge type

13: cartridge not seated properly, or not present

Xerox N-24/32/40

OEM Stated Yield: 20-23,000 (Depending on cartridge)

This engine has more non-interchangeable cartridges than any engine I have

ever seen. All of them use a "ARD" that is built into the connector. Almost

every type of cartridge has it's own individual ARD. Since every in

ividual

cartridge has it's own chip, it is imperative that you have the OEM cartridge

part number when ordering the chips! The reset boards are now available with

the plastic housing so that soldering the chip in is no longer necessary.

There are also services where you can have the old chip reset. There are

still cartridges that do not have replacement chips available yet. These are

mainly international, but not all. A chart list of the available versions is

on page 119

Xerox P8E (Samsung FS-5000 Engine)

OEM Stated Yield: 5,000 (Except for Lexmark 13TOI0l: 6,000)

There are 3 main versions of this cartridge so far. The Xerox Docuprint P8e

l13R296/l 00R364, WorkCentre 385 l13R 296, and the Lexmark Optra E3l 0/312

NOTE: Lexmark has replaced the l2A2202 (5k)

artridge with the l3TOlOl (6k)

cartridge. The new cartridge works in both machines.

hen recycling these

cartridges the fuse must be replaced in the Xerox cartridges. The Lexmark

cartridges have a plastic dummy fuse in it. There has been some conflicting

information on if the fuse should be replaced or not, the following should

help to clear it up. If the machine says toner low and the cartridge is

changed. A new fuse is not needed. However if the machine says change

cartridge, that fuse is needed. Since y

u really have now way to know the

state of your customer's machine, we recommend that the fuse be replaced each

cycle. These fuses are very inexpensive, and this way you have no worries!

There have recently been reports of starter cartridges with the plastic dummy

fuses. Those fuses must be replaced with a real fuse. These fuse is a 125V,

100mA, 5x20mm fast acting glass type.

1 2 ... 26 27 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments

Brother HL-630 User Manual Page 31

Comments to this Manuals

Related products and manuals for Print & Scan Brother HL-630