Brother DCP-750CW User Manual download pdf (Page 27)

Installing the Driver & Software

25

Windows

®

Windows

®

Wireless

Network

Using the Setup Wizard from the control panel LAN menu for wireless

network configuration

Important

Make sure that you have finished the

instructions from Step 1 Setting Up the

Machine on page 4 through 11.

1 Write down the wireless network settings of

your access point or wireless router.

SSID (Service Set ID or Network name)

_________________________

WEP Key (if needed)

________________________

WPA/WPA2-PSK (TKIP or AES) (if needed)

_________________________

The WEP key is for 64 bit encrypted networks

or 128 bit encrypted networks and can contain

both numbers and letters. If you do not know

this information you should see the

documentation provided with your access point

or wireless router. This key is a 64-bit or 128-bit

value that must be entered in an ASCII or

HEXADECIMAL format.

For example:

WPA/WPA2-PSK enables a Wi-Fi

®

Protected

Access Pre-shared key (WPA/WPA2-PSK),

which lets the Brother wireless machine

associate with access points using TKIP or

AES encryption (WPA-Personal). WPA/WPA2-

PSK (TKIP or AES) uses a Pre-Shared Key

(PSK) that is more than 7 and less than 64

characters in length.

See the Network User’s Guide for more details.

2 Turn on the machine by connecting the power

cord.

Improper Setup

If you have previously configured the wireless

settings of the machine you must reset the

network (LAN) settings before you can

configure the wireless settings again.

On your machine, press Menu.

Press a or b for LAN and press OK.

Press a or b to choose Factory Reset, and

then press OK.

Press to choose Yes.

Press to choose Yes.

3 On your machine, press Menu.

Press a or b to choose LAN and press OK.

Press a or b to choose Network I/F and

press OK.

Press a or b to choose WLAN and press OK.

The wired network interface will become

inactive with this setting.

It will take about a minute for the LAN menu on

the LCD to become available again.

Press Stop/Exit.

4 When the LAN menu becomes available, press

Menu.

Press a or b to choose LAN and press OK.

Press a or b to choose Setup WLAN and

press OK.

Press a or b to choose Setup Wizard and

press OK.

This will start the wireless setup wizard.

64 bit ASCII:

Uses 5 text characters.

e.g. “Hello” (this is case sensitive)

64 bit

Hexadecimal:

Uses 10 digits of hexadecimal data.

e.g. “71f2234aba”

128 bit ASCII:

Uses 13 text characters.

e.g. “Wirelesscomms” (this is case

sensitive)

128 bit

Hexadecimal:

Uses 26 digits of hexadecimal data.

e.g. “71f2234ab56cd709e5412aa3ba”

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 50 51

Comments to this Manuals

No comments