Raster Command Reference
- 5 -
2. Print Data
2. Print Data
2.1 Print data overview
The print data is constructed of the following: (1) initialization commands, (2) control codes, (3) raster data,
and (4) print commands. If the print job consists of multiple pages, (2) through (4) are repeated.
(1) Initialization commands
Specified only once at the beginning of the job.
Sends a 100-byte invalidate command, and then resets the printer
to the receiving state.
Initializes for printing.
1Bh, 40h (Fixed)
(2) Control codes
Added at the beginning of each page and sent for each page.
Switch dynamic
command mode
Switches the printer to raster mode.
1Bh, 69h, 61h, 01h
Print information
command
Sets the print information for the printer.
When printing 100 mm on 24-mm-wide tape with the 180 dpi
model:
1Bh, 69h, 7Ah, 84h, 00h, 18h, 00h, 9Ch, 02h, 00h, 00h, 00h, 00h
When auto cut is enabled:
1Bh, 69h, 4Dh, 40h
When chain printing is disabled:
1BH,69H,4B,08H
Specifies the amount of the margins.
For 2 mm margins on the 180 dpi model:
1Bh, 69h, 64h, 0Eh, 00h
Selects the compression mode for raster graphics.
To send the data compressed to TIFF format:
4Dh, 02h
Comments to this Manuals