Brother Computerized Sewing Machine Instruction Manual Page 95
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
93
4
Troubleshooting
If the machine stops operating correctly, check for the following possible causes before requesting service.
If the problem persists, contact your dealer or the nearest authorized service center.
Symptom Probable Cause Remedy Reference
The sewing
machine does
not operate.
The plug of the power cord is not
inserted into an electrical outlet.
Insert the plug of the power cord into
a household electrical outlet.
page 14
The machine is not turned on. Turn on the machine. page 14
The bobbin winder shaft is moved to
the right.
Slide the bobbin winder shaft to the
left.
page 17
The presser foot lever is raised. Lower the presser foot lever. page 42
A stitch other than the buttonhole or
bar tack stitch was selected and the
start/stop button was pressed while
the buttonhole lever is lowered.
Raise the buttonhole lever. –
The buttonhole or bar tack stitch was
selected and the start/stop button was
pressed while the buttonhole lever is
raised.
Pull down the buttonhole lever. page 59
The start/stop button was pressed,
even though the foot controller is
connected.
Do not use the start/stop button when
the foot controller is connected. To
use the start/stop button, disconnect
the foot controller.
page 42
The needle
breaks.
The needle is incorrectly installed. Correctly install the needle. page 29
The needle clamp screw is loose.
Use the screwdriver to firmly tighten
the screw.
page 30
The needle is bent or blunt. Replace the needle with a new one. page 29
The combination of fabric, thread and
needle is incorrect.
Select a thread and needle that are
appropriate for the type of fabric
being sewn.
page 28
The appropriate presser foot for the
type of stitch that you wish to sew is
not used.
Attach the presser foot that is
appropriate for the type of stitch that
you wish to sew.
page 87
The upper thread tension is too tight. Loosen the upper thread tension. page 47
The fabric is pulled too much. Lightly guide the fabric. –
The area around the hole in the
needle plate is scratched.
Replace the needle plate.
Contact your dealer or the nearest
authorized service center.
–
The area around the hole in the
presser foot is scratched.
Replace the presser foot.
Contact your dealer or the nearest
authorized service center.
–
The bobbin case is scratched.
Replace the bobbin case.
Contact your dealer or the nearest
authorized service center.
–
A bobbin designed specifically for
this machine is not used.
Bobbins from older models, which
have a different thickness, will not
work properly. Only use a bobbin
designed specifically for this
machine.
page 15
- Operation Manual 1
- IMPORTANT SAFETY INSTRUCTIONS 3
- 6 This machine is not a toy: 4
- 7 For a longer service life: 4
- SAVE THESE INSTRUCTIONS 5
- IMPORTANT 6
- Contents 8
- Introduction 10
- Operation buttons 11
- Operation panel 12
- Flat bed attachment 12
- * 75/11 2 needles 13
- 90/14 2 needles 13
- Optional accessories 14
- 1 GETTING READY 15
- Turning on the machine 16
- Turning off the machine 16
- Winding the bobbin 17
- Installing the bobbin 20
- X The cutter cuts the thread 21
- Threading the upper thread 22
- Using the twin needle 27
- X The LCD comes on 28
- Replacing the Needle 29
- Needle types and their uses 30
- Checking the needle 31
- Replacing the needle 31
- Replacing the Presser Foot 33
- Removing the presser 34
- Using the optional walking 35
- ■ Removing the walking foot 36
- X The needle is raised 36
- X The presser foot is raised 36
- Useful Functions 37
- Changing the initial needle 38
- Stitching cylindrical pieces 39
- Sewing large pieces of fabric 39
- 2 SEWING BASICS 41
- Selecting a stitch 42
- Adjusting the stitch length 42
- Positioning the fabric 43
- Starting to sew 44
- Securing the stitching 46
- Cutting the thread 48
- Automatically sewing reverse/ 48
- Adjusting the thread tension 49
- Useful Sewing Tips 50
- Sewing thin fabrics 51
- Sewing stretch fabrics 51
- Pulling up the bobbin thread 52
- 3 UTILITY STITCHES 53
- Basic Stitching 55
- Blind Hem Stitching 56
- Buttonhole Stitching 58
- ■ Changing the stitch length 61
- ■ Changing the stitch width 62
- Button sewing 63
- Zipper Insertion 65
- Inserting a side zipper 66
- Stretch stitching 69
- Elastic attaching 69
- Appliqué stitching 72
- Patchwork (crazy quilt) 72
- Quilting 73
- Free-motion quilting 74
- Reinforcement Stitching 76
- Bar tack stitching 77
- Decorative stitching 79
- Fagoting 80
- Scallop stitching 80
- Smocking 81
- Shell tuck stitching 81
- Heirloom stitching 82
- ■ Drawnwork (Example 1) 83
- ■ Drawnwork (Example 2) 83
- Select stitch 84
- (page 40) 84
- 4 APPENDIX 89
- Maintenance 93
- Removing the needle plate 94
- Troubleshooting 95
- Error Message 99
- (in LCD) 99
- Probable Cause Remedy 99
- Operation beep 100
- , 33, 71 102
Related products and manuals for Sewing machines Brother Computerized Sewing Machine
Sewing machines Brother XL-6050 User Manual
(175 pages)
(175 pages)
(98 pages)
Sewing machines Brother CS-6000i User Manual
(66 pages)
(66 pages)
Sewing machines Brother 885-X11 User Manual
(44 pages)
(44 pages)
Sewing machines Brother CE-8080 User Manual
(104 pages)
(104 pages)
Sewing machines Brother CS-80 Instruction Manual
(115 pages)
(115 pages)
© 2020, manymanuals.com. All rights reserved. | 1.931 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals