Brother CS-8150 User Manual download pdf (Page 103)

Reinforcement Stitching 97

GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX

Darning

Fabric that has been torn can be darned.

Darning is sewn as shown below.

Determine the desired length of the darning.

Set the button guide plate on buttonhole foot

“A” to the desired length. (The distance

between the markings on the presser foot scale

is 5 mm (3/16 inch).)

1 Presser foot scale

2 Length of darning

3 5 mm (3/16 inch)

4 7 mm (1/4 inch)

• A bar tack with a maximum length of about

28 mm (1-1/8 inch) can be sewn.

Attach buttonhole foot “A”.

• For details, refer to “Replacing the presser

foot” (page 41).

Select stitch

• For details, refer to “Selecting stitching”

(page 66).

Position the fabric so that the needle is 2 mm

(1/16 inch) in front of the area to be darned,

and then lower the presser foot lever.

1 Tear

2 2 mm (1/16 inch)

Pass the upper thread down through the hole

in the presser foot.

• When lowering the presser foot, do not push

in the front of the presser foot, otherwise the

darning will not be sewn with the correct

size.

1 Do not reduce the gap.

1 Reinforcement stitching

S3_brotherE.book Page 97 Thursday, May 15, 2003 1:58 PM

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 140 141

No comments

Brother CS-8150 User Manual Page 103