Brother CS-8150 User Manual download pdf (Page 35)

Upper Threading 29

GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX

• If the needle is not raised to the correct

position, the needle cannot be threaded with

the needle threader. Be sure to check that

the thread cassette indicator is lit up in green

before inserting the thread cassette.

Insert the thread cassette into the thread

cassette compartment.

Slowly press down on the thread cassette until

it clicks into place.

1 Needle bar thread hook

X At the same time that the thread cassette is

inserted, the needle is threaded.

X The thread cassette indicator goes off.

• If the needle could not be threaded or the

thread was not passed through the needle

bar thread hook, refer to “Loading the spool

into the thread cassette” (page 25) and

perform the procedure again starting from

step

Raise the presser foot lever, carefully pull on

the loop of thread passed through the eye of

the needle to pull out the end of the thread.

Pass the thread through the presser foot, and

then pull out about 10-15 cm (3/8-5/8 inch)

of thread toward the rear of the machine.

1 10-15 cm (3/8-5/8 inch)

X The upper threading is finished.

●

The needle threader is operated when the

needle is threaded. Be sure to keep your

hands and other items away from the

needle, otherwise injuries may occur.

CAUTION

1 Push here

S3_brotherE.book Page 29 Thursday, May 15, 2003 1:58 PM

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 140 141

No comments

Brother CS-8150 User Manual Page 35