Brother CS-8150 User Manual download pdf (Page 41)

Upper Threading 35

GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX

Pulling up the bobbin thread

When making gathers or before free-motion quilting,

first pull up the bobbin thread as described below.

Insert the bobbin into the shuttle.

• Refer to steps

through

of “Installing the

bobbin” (page 22).

Pass the bobbin thread through the slot.

Do not cut the thread with the cutter.

While lightly holding the upper thread with

your left hand, press (needle position

button) twice to raise the needle.

1 Needle position button

X The bobbin thread is looped around the

upper thread and can be pulled up.

Carefully pull the upper thread upward to pull

out the end of the bobbin thread.

Pull out about 10-15 cm (3/8-5/8 inch) of the

bobbin thread under the presser foot toward

the rear of the machine.

Reattach the bobbin cover.

Insert the tab in the lower-left corner of the

bobbin cover, and then lightly press down on

the right side.

S3_brotherE.book Page 35 Thursday, May 15, 2003 1:58 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 140 141

No comments

Brother CS-8150 User Manual Page 41