Brother HL7050 User Manual Page 137

  • Download
  • Add to my manuals
  • Print
  • Page
    / 164
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 136
13 - 1 TROUBLESHOOTING
13
YL4US_FAX2800MFC4800-FM5.5
13
Troubleshooting
Overview
This chapter describes procedures for troubleshooting problems you
may encounter with a Brother print server, it is divided into the
following sections:
1
Installation Problems
2
Intermittent Problems
3
Protocol-Specific Troubleshooting
Installation problems
If you cannot print over the network, check the following:
1
Make sure that the printer is powered on, is on-line and ready to
print.
Verify that the printer and the configuration are good by printing
the configuration page. Refer to the Quick Setup Guide. If the
test fails, check:
a
If the LED is not blinking after connected to the network, then
the network firmware settings may be corrupted. Please refer
to Step 3.
b
In this event, try to restore the factory default settings of the
print server by pressing the TEST switch on the back panel of
the printer for longer than 5 seconds. Once you have done
that, switch the printer off and then on again, and try to print
out the configuration page.
2
If the configuration page prints but you cannot print documents,
try the following
If none of the following steps are successful, there is almost
certainly a hardware or network problem!
Page view 136
1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 163 164

Comments to this Manuals

No comments