Brother WL-660 Setup Guide download pdf (Page 8)

English

Action 6: Set up the Printer Driver and Fonts for Windows 3.1

Check the following system requirements to run the Setup program and operate the printer

correctly:

• IBM PC or compatible with 80486 SX or higher microprocessor

• Parallel interface (or printer port)

• 4 MB or more of memory

• 10 MB of space available on your hard disk for the printer driver and all fonts

• Microsoft Windows 3.1/3.11

CAUTION

This printer has been designed specially for Windows 3.1. It cannot work in a DOS

environment such as MS-DOS.

You need to set up this printer by installing the printer driver and TrueType-compatible fonts

into Windows 3.1. Because the supplied printer driver and fonts are compressed on the disk,

be sure to use the supplied Setup program to install them as follows:

1. Start Windows 3.1.

2. Insert the supplied disk into your floppy disk drive A (or drive B).

3. Choose Run from the File menu in the Program Manager.

4. Type A:\SETUP (or B:\SETUP for drive B) in the Command Line box.

5. Choose the OK button or press the Enter key.

6. Follow the instructions that appear on the display monitor.

7. When the installation is complete, remove the disk from the drive.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Brother WL-660 Setup Guide Page 8