Brother PT-9200DX User Manual download pdf (Page 8)

Connecting the interface and power supply cables

Connect the PT-9200DX to the computer according to the instructions below.

When connecting to the serial port:

1 Make sure that both the PT-9200DX and the computer are turned off.

2 Connect one end of the enclosed serial interface cable to the serial connector (IOIOI) of the PT-9200DX and the

other end of the cable to the serial port of the computer. For a Macintosh connection, connect the PT-9200DX to

either the modem or the printer port (preferably the modem port).



The serial (RS-232C) ports of some computers are shaped so that the serial interface cable cannot be con-

nected. If this is the case, use a commercially available adapter.

3 Insert the plug on one end of the power supply cord into the power supply jack on the PT-9200DX.

4 Insert the plug on the other end of the power supply cord into an AC outlet equipped with a grounding terminal.

Some locations may require the use of an adapter provided with a grounding wire. Connect this wire to the ground

terminal.

5 Turn on the PT-9200DX, and then turn on the computer.

Serial

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 231 232

No comments

Brother PT-9200DX User Manual Page 8