Brother NX-450 User Manual download pdf (Page 110)

Reinforcement Stitching 109

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Darning

Fabric that has been torn can be darned.

Darning is sewn as shown below.

a Reinforcement stitching

Determine the desired length of the darning.

Set the button guide plate on buttonhole foot

“A” to the desired length. (The distance

between the markings on the presser foot scale

is 5 mm (3/16 inch).)

a Presser foot scale

b Length of darning

c 5 mm (3/16 inch)

d 7 mm (1/4 inch)

Attach buttonhole foot “A”.

• For details, refer to “Replacing the presser

foot” (page 41).

Select stitch

• For details, refer to “Selecting stitching” (page

72).

Position the fabric so that the needle is 2 mm

(1/16 inch) in front of the area to be darned,

and then lower the presser foot lever.

a Tear

b 2 mm (1/16 inch)

Pass the upper thread down through the hole in

the presser foot.

• When lowering the presser foot, do not push

in the front of the presser foot, otherwise the

darning will not be sewn with the correct

size.

a Do not reduce the gap.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 154 155

No comments

Brother NX-450 User Manual Page 110