Brother SE-270D Instruction Manual download pdf (Page 33)

Upper Threading 27

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Carefully pull on the loop of thread passed

through the eye of the needle to pull out the

end of the thread.

• When embroidering, go to

Pass the thread through the presser foot, and

then pull out about 10-15 cm (3/8-5/8 inch) of

thread toward the rear of the machine.

a 10-15 cm (3/8-5/8 inch)

X The upper threading is finished.

Close the thread cassette compartment cover.

X Now that the upper threading and the lower

threading are finished, you are ready to

begin sewing.

• When embroidering, go to c in

"Embroidering a pattern" (page 134).

Note

z When inserting the thread cassette into its

compartment, slowly press it down.

z If the sewing machine could not be

threaded, try performing the procedure

again starting from loading the spool of

thread into the thread cassette.

Using the extra spool pin

When using spools with a size that cannot be loaded

into the thread cassette, use the extra spool pin.

Place the spool of thread onto the extra spool

pin.

a Extra spool pin

b Spool

Slide the spool cap for the size of the spool

onto the spool pin.

a Spool cap

• For more details, refer to "About the spool of

thread" (page 21).

Insert the tabs on the extra spool pin into the

holes on the top of the thread cassette.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 165 166

No comments

Brother SE-270D Instruction Manual Page 33