Brother STAR 120E Service Manual download pdf (Page 56)

- 54 -

1. REMOVING THE COVERS

1. Remove the face plate screw, then remove the face plate by pulling it off to the left.

2. Remove the free-arm cover screw, then remove the free-arm cover by pulling it off to the left.

3. Pull the thread cutter operation lever off toward you.

4. Loosen the two front cover screws (at the bottom corner near the face plate and at the bottom of the free

arm), then lift the front cover toward you from the bottom, disconnect the connector, remove the front

cover and pull the reverse sewing button off toward you.

5. Pull the switch cover off to the right from the top of the cover.

6. Lower the presser foot lever, remove the three rear cover screws, and pull the rear cover off toward the

rear.

7. Pull the BH adjustment knob off to the right.

NOTE

INSTALLING THE FRONT COVER

A. Set the pattern dial to the zigzag stitch (The second position when turning the pattern dial clockwise after

fully turning it counterclockwise.).

B. Set the pattern on the front cover to the zigzag stitch "3".

























B375, B376 and B377

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62

No comments

Brother STAR 120E Service Manual Page 56