Brother XE5427-001 User Manual download pdf (Page 36)

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Cut the thread with scissors beside the bobbin-

winding thread guide.

a Bobbin-winding thread guide

Slide the bobbin winder shaft to the left, and

then remove the bobbin from the shaft.

Hold the thread end with your left hand, and

wind off the thread clockwise near the bobbin

with your right hand as shown below.

Wind the bobbin again.

Note

z Make sure that the thread passes under the

pretension disk of the bobbin-winding

thread guide correctly (page 31).

Installing the bobbin

Install the bobbin wound with thread.

CAUTION

Memo

z The order that the bobbin thread should be

passed through the bobbin case is indicated

by marks that surround the bobbin case.

● Use a bobbin that has been correctly

wound with thread, otherwise the needle

may break or the thread tension will be

incorrect.

● The included bobbin was designed

specifically for this machine. If bobbins

from other models are used, the machine

will not operate correctly. Use only the

included bobbin or bobbins of the same

type (part code: SA156, SFB (XA5539-

151)).

This model

Other model

11.5 mm

(7/16 inch)

Actual size

0711-0120-C-combo_E.book Page 34 Thursday, July 24, 2008 1:46 PM

1 ... 35 36 37 ... 92

No comments

Brother XE5427-001 User Manual Page 36