Brother MFC-990CW Setup Guide download pdf (Page 11)

Set up the cordless handset (MFC-990CW only)

Install the battery

a Insert the connector a of the battery b in the

direction shown below.

b Place the battery in the position shown.

c Install the battery cover by sliding it onto the

back of the handset.

d Charge the battery by leaving the cordless

handset in the cradle for at least 12 hours

before you use it.

You can continue to set up the handset during

this time.

Charge the battery

a Place the cordless handset on the cradle with

the dial pad facing forward.

Set your country on the

cordless handset

The first time you install the battery, you must set your

country so that the cordless handset works correctly

on local telecommunication lines.

a The LCD shows:

Set Country

Press OK Key

b Press Menu/OK.

c Press a or b to choose your country.

Press Menu/OK.

d Press 1 to confirm.

Note

Be careful that you do not catch the battery

connector cord.

Note

• After battery replacement of the cordless

handset, you should set the date and time.

(See Date and Time in the DECT™ Handset

BCL-D70 User’s Guide.)

• If your battery charge level is getting low, you

should charge the battery. You can see the

battery charge level indicator at the bottom

right of the LCD.

Note

The LCD of the handset will display

“Searching for Base Unit” or

“Base Unit not detected” until the initial

setup of the machine is complete.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 46 47

Comments to this Manuals

No comments

Brother MFC-990CW Setup Guide Page 11

Comments to this Manuals

Related products and manuals for Copiers Brother MFC-990CW