Brother DCP 8060 User Manual download pdf (Page 82)

To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can

set or change the address settings from the control panel (See the Network User’s Guide on the CD-ROM).

If you installed the machine following the instructions for a network user in the Quick Setup Guide then the

machine should already be configured for your network.

Before using Network Scanning 4

Network license 4

This product includes a PC license for up to 5 Users.

This license supports the installation of the MFL-Pro Software Suite including ScanSoft

PaperPort

on up

to 5 PCs for use on a network.

If you want to use more than 5 PCs with ScanSoft

PaperPort

installed, please buy NL-5 which is a multiple

PC license agreement pack for up to 5 additional users. To buy NL-5, contact your Brother Sales Office.

Note

• Max. of 25 clients can be connected to one machine on a network. For example, if 30 clients try to connect

at a time, 5 of those clients will not be shown on the LCD.

• If your PC is protected by a firewall, and is unable to scan, you may need to configure the firewall settings

to allow communication through port number 137 and 54925. Visit the Brother Solutions Center

(http://solutions.brother.com

) for more information.

• Network Scanning is not supported in Wndows NT

Network Scanning (For models with

built-in network support)

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 181 182

No comments

Brother DCP 8060 User Manual Page 82