Brother HL 1270N User Manual download pdf (Page 103)

A-1

APPENDIX

Appendix A

Command Summary

General Commands

You can change the configuration of your print server using any of the following methods.

• Brother BRAdmin32 utility for Windows 95/98 and NT 4.0

• HTTP (using a web browser)

• TELNET (command utility)

• Brother BRCONFIG NetWare Utility (command utility)

BRAdmin32 The Brother BRAdmin32 utility can use the TCP/IP or IPX/SPX protocol.

This utility allows you to graphically manage aspects of the network and

printer. It runs on Windows 95/98 and Windows NT 4.0

HTTP Use your favorite web browser to connect to the Brother print server. This

will allow you to configure print server parameters. You must ensure that the

print server has a valid IP address. Once you have done this type

http://ip_address/ in your web browser. If you can not connect to

the print server check your web browser is configured correctly (check your

proxy settings to ensure that your web browser can connect to the printer on

your internal network). When ever you wish to change a print server

parameter you will be asked for a password. The default password is “access”

TELNET To connect to the print server using TELNET on UNIX, Windows NT, or

most other TCP/IP systems, type: TELNET

ipaddress

at the command

prompt of the system prompt, where ipaddress is the IP address of the print

server. When you are connected, push RETURN or ENTER to get the "#"

prompt, enter the password "access" (the password will not appear on the

screen), and type anything in response to the Enter Username> prompt.

When you see the Local> prompt, you are ready to enter commands.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 121 122

No comments

Brother HL 1270N User Manual Page 103