Brother PE 300S User Manual download pdf (Page 37)

Contents Setting Up

Basic Sewing

Machine

Operation

Utility Stitches Embroidering

Maintenance

Troubleshooting

Error

Messages

Sewing Chart

Patterns

(Programmed

in Machine)

Patterns

(Memory Card)

NEEDLE

CAUTION

– Always make sure to turn the machine off before changing needles. There is a danger of injury

if the machine accidentally starts running during this operation.

– Never use bent or damaged needles. If the needle breaks while sewing, the broken tip could fly

away from the machine and cause injury.

1. Turn off the power.

2. Lower the presser foot.

3. Loosen the needle clamp screw with a screwdriver. Pull out

the needle.

1 Disc-shaped screwdriver

CAUTION

Do not loosen or tighten the needle

clamp screw with a strong force,

otherwise it way be damaged.

4. With the flat side of the needle facing the back, insert the nee-

dle as far as it will go up against the needle stopper.

5. Fasten the screw securely with a screwdriver.

1 Needle stopper

Checking the needle

Installing the needle securely

Place the needle on a flat surface and check whether the space

between the needle and the flat surface is parallel or not.

If the space is not parallel then the needle is bent and should be

thrown away to prevent damage to your project or to the machine.

1 Space between the needle and the flat surface

2 Flat surface (needle plate, glass, ruler, etc.)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 110 111

No comments

Brother PE 300S User Manual Page 37