Brother HL-S7000DN User Manual download pdf (Page 13)

IPsec Settings

 Service Name

Enter a name for the service in this box. (Maximum of 16 characters)

 Direction

Specify the communication direction. Select Initiator, Responder, or Both.

 Protocol

Specify the protocol that is enabled. Select ALL, TCP, UDP, or ICMP. The setting items are different

depending on the selected Protocol.

• When TCP or UDP is selected, register the Local Port/Remote Port.

• When ICMP is selected, register the Type/Code.

Note

ICMP is a protocol that is used to send IP error messages and control messages. This protocol is used by

computers and network devices connected using TCP/IP in order to carry out mutual status confirmation.

 Local Port/Remote Port (When TCP or UDP is selected in Protocol.)

Enter the local port number. If Single is selected, enter one port number. If Range is selected, enter

the starting port number, and then enter the ending port number. When you want to enable all port

numbers, select Range and enter "1-65535" without the double quotation marks.

 ICMP(Local)/ICMP(Remote) (When ICMP is selected in Protocol.)

Configure the ICMP settings. Select Any or enter the Type/Code. For details about the Type/Code,

see Appendix A.

 Setup Service

Click this button to return to the Setup Service screen.

(Protocol: ICMP)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

No comments

Brother HL-S7000DN User Manual Page 13