Brother MFC-J2510 User's Guide download pdf (Page 23)

Configuring your machine for a wireless network

(For MFC-J2510/J4510DW/J4710DW) 3

a Press .

b Press Wi-Fi.

c Press WPS w/PIN Code.

d When Switch Network interface to wireless? is displayed, press Yes to accept.

This will start the wireless setup wizard.

To cancel, press No.

e The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for

up to 5 minutes.

f Using a computer that is on the network, type “http://access point’s IP address/” into your browser.

(Where “access point’s IP address” is the IP address of the device that is used as the Registrar

.) Go to

the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in e to the

Registrar and follow the on-screen instructions.

The Registrar is normally the WLAN access point/router.

NOTE

The setting page may be different, depending on the brand of WLAN access point/router. See the

instruction manual that came with your WLAN access point/router.

If you are using your Windows Vista

or Windows

7 computer as a Registrar, complete the following

steps.

NOTE

To use a Windows Vista

or Windows

7 computer as a Registrar, you need to register it to your network

in advance. See the instruction manual that came with your WLAN access point/router.

1 (Windows Vista

)

Click , Network, and then Add a wireless device.

(Windows

Click , Control Panel, Network and Internet, and then

Add a wireless device to the network.

2 Choose your machine and click Next.

3 Input the PIN from the printed page and then click Next.

4 Choose your network that you want to connect to, and then click Next.

5 Click Close.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

No comments

Brother MFC-J2510 User's Guide Page 23