Brother P-Touch 3600 User's Guide download pdf (Page 47)

Ch. 2 Getting Started

Getting Started

6 Hold the end of the stamp film in place with

your thumb, and then pass the stamp film

through the guides while pulling it tight.

7 Fold the other end of the stamp film over

the other side of the stamp holder and hold

it in place with your finger.

8 Fit the frame over the stamp film, and then

push the frame down into place.

9 Insert the stamp holder straight into the cap.

Attaching the identification label

1 Insert a TZ tape cassette into the tape com-

partment.

2 Press p to print out the identification label.

3 After the label is cut off, affix it to the end of

the holder so that its bottom edge is on the

same side of the stamp holder as the raised

“brother” logo.

Tape end

Glossy side

Slit

Fold over

Guides

NOTE

☞

Be sure that the cap correctly covers the stamp

in order to prevent ink spills.

☞

When the stamp is not being used, firmly cover

it with the cap and always store it standing up

with the stamp facing downward. Do not leave

the stamp laying on its side or leaning.

☞

Store stamp film holders and stamp film cas-

settes in a location where they are not exposed

to high temperatures, high humidity or direct

sunlight.

NOTE

Use 1/2" (12-mm)-wide tape to make an identifica-

tion label for an M-size stamp and use 3/4" (18-

mm)-wide tape to make a label for an L-size stamp.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 203 204

No comments

Brother P-Touch 3600 User's Guide Page 47