Brother HL7050 User Manual download pdf (Page 160)

APPENDIX A - 7

YL4US_FAX2800MFC4800-FM5.5

Reloading using the FTP Protocol from a

command prompt

By specifying the print server PASSWORD AS THE USERNAME

when logging on, it becomes possible to upgrade the firmware of the

print server or printer (if supported). The following example assumes

that the print server password is "cambridge"

D:\>ftp

ftp> open 220.0.250.200

Connected to 220.0.250.200.

220 FTP print service:V-1.05/Use the network

password for the ID if updating.

User (220.0.250.200:(none)): cambridge

230 User cambridge logged in.

ftp> bin

200 Ready command OK.

ftp> hash

Hash mark printing on ftp: (2048 bytes/hash mark) .

ftp> send brnt261.blf

200 Ready command OK.

150 Transfer Start

#################################################

########

#################################################

###########################

226 Data Transfer OK/Entering FirmWareUpdate mode.

ftp: 1498053 bytes sent in 8.52Seconds

175.77Kbytes/sec.

ftp> close

226 Data Transfer OK.

ftp> quit

When you see "226 Data Transfer OK/Entering FirmWareUpdate

mode", you can be sure that the firmware file is being transferred to

the print server. If you do not see this message, the file you are

sending to the printer will either be ignored or the printer will print

garbage.

You must use the "bin" command to put the FTP client into

Binary communications mode. If you do not specify the bin

command the upgrade process will not function correctly.

1 2 ... 155 156 157 158 159 160 161 162 163 164

No comments

Brother HL7050 User Manual Page 160