Brother RH-9820 Service Manual download pdf (Page 84)

6. ASSEMBLY

RH-9820

A Tie one end of the wick (1) once, and then push that end into the hole (a) in the support shaft base (43).

* Push in so that the knot does not protrude from the hole (a).

(Viewed from the front) (Viewed from the right)

1) Tie one end of the wick (8) once, and then push that end into the hole (b) in the LS holder base (34).

* Push in so that the knot does not protrude from the hole (b).

2) Tie the other end of the wick (8) to one end of the wick (9), and then wind them around the LS holder

base (34) as shown in the illustration.

* Tie the wicks twice to form the knot.

* Wind so that the knot is directly below the hole (c) and so that it does not protrude to the outside.

* Wind the wick (8) and the wick (9) so that they are positioned as shown in the illustration.

1185B

(Viewed from the left)

(Viewed from the front)

1184B

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 235 236

No comments

Brother RH-9820 Service Manual Page 84