Brother MFC7150C User Manual download pdf (Page 117)

102

CHAPTER TWELVE

Remote Control Commands

Follow the commands below to access features remotely. When you call the

MFC and enter your Remote Access Code (159 ), the system will signal

you with two short beeps to enter a remote control command.

Remote Control Commands

91 Playing voice messages

1 (Skip back)

2 (Skip next)

9 Stop Playing

92 Record Memo

93 Erase all ICM & Memo

94 Play and Record OGM

in memory

1 Play 1 MSG CTR OGM

2 F/T OGM

2 Record 1 MSG CTR OGM

2 F/T OGM

95 Changing Fax Forwarding/

Paging setting

1 OFF

2 Fax Forwarding

3 Paging

4 FAX FWD NO.

96 Retrieve Fax

1 Memory Status List

2 Retrieve all FAX

3 Erase FAX in the

memory

Details Operation

After one long beep, the MFC plays ICMs and Memos.

Press 1 while listening to an ICM or Memo message to play

it again. If you press 1 before a message, you will reply the

previous message.

While playing an ICM or Memo, you can skip to next

message.

Stop playing the ICM and Memo.

After one long beep, you can record a memo. You can stop

recording by pressing 9.

If you hear one long beep, the erase is accepted. If you hear

three short beeps, you cannot erase because all voice messages

have not been played, or there is no voice message to erase.

*This code erases all recorded messages, not one at a time.

The MFC plays the selected OGM. You can stop playing

OGMs by pressing 9.

After one long beep, you can record the selected OGM. Your

recorded message will be played when you finish speaking.

You can stop recording the message by pressing 9.

If you hear one long beep, the change is accepted. If you hear

three short beeps, you cannot change it because the conditions

have not been met (Example: registering paging number). You

can register your fax forwarding number by using 4. FAX

FWD NO (see page 104). Once you have registered the

number, the MFC will automatically change to

“FAXFWD:ON” mode. Then retrieve a Memory Status List by

entering 961 (see page 103) to make sure that the Fax

Forwarding number you registered is correct in the List.

Enter the number of a remote fax machine to receive a report

or stored fax messages. (See page 103.)

If you hear one long beep, you can erase the fax message

from the memory.

97 Check the receiving status

1 FAX

2 VOICE

98 Change Answer Mode

1 MSG CTR

2 FAX/TEL

3 FAX

90 Exit

You can check whether your MFC has received any FAX or

VOICE messages. If yes, you will hear one long beep. If no,

you will hear three short beeps.

If you hear one long beep, you can change the answer mode.

If you hear three short beeps, you cannot change it (For

example: When there is no MSG CTR OGM and you tried to

change to MSG CTR mode.)

After a long beep, you can exit remote control.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 274 275

Comments to this Manuals

No comments

Brother MFC7150C User Manual Page 117

Comments to this Manuals

Related products and manuals for Faxes Brother MFC7150C