Brother MFC7150C User Manual download pdf (Page 33)

CHAPTER TWO

Press

on the dial pad for each color, as prompted (for initial setup only)

within 1 minute. The MFC will enter a cleaning cycle for approximately 6

minutes. The screen alternately displays CLEANING BLACK and

PLEASE WAIT. The ink dot counter will be set automatically for each

color, so the MFC can warn you with an error message when ink is running

low.

Make sure paper is loaded in the cassette, then press

Start

within 1

minute.

When the MFC completes the cleaning cycle, the MFC starts printing the

test sheet.

Only during initial ink cartridge installation, the screen shows.

PRINT OK?

1.YES 2.NO

Check the print quality of the test sheet. If it is not good, clean the print

head again, by pressing

. The screen will ask you if the print quality is

OK for each color. Press

for any color with a problem. You can choose

several colors. After cleaning is finished, press

Start

The MFC starts printing Test Sheet No. 2.

Adjust the Vertical Alignment by following the instructions printed on the

Test Print page.

WARNING

If ink gets in your eyes, irrigate them with water immediately and consult a

doctor if you are concerned.

Caution

■ DO NOT remove ink cartridges if you do not need to replace them. If

you do so, it may reduce the ink quantity and the MFC will not know the

quantity of ink left in the cartridge.

■ DO NOT shake the ink cartridges. If you do so, the ink may spill when

you take off the sealing tape. If ink stains your body or clothing, wash

with soap or detergent immediately.

■

If you install an ink cartridge in the wrong color position, you must clean

the print head several times after correcting the cartridge installation and

before you start printing because the colors were mixed.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 274 275

No comments

Brother MFC7150C User Manual Page 33