Brother BAS-342G Instruction Manual download pdf (Page 21)

4. INSTALLATION

BAS-342G

4-13. Connecting the cords [8]

1. Remove the cover of the control box.

2. Loosen the two screws (1), and then

open the cord presser plate (2) in the

direction of the arrow.

3. Pass the bundle of cords from the

machine head through the hole in the

table, and then pass it through the

hole in the control box together with

the following cords.

• Tow-pedal foot switch (3)

• Operation panel (Do not pass the

ground wires through the hole.)

• Solenoid valve assembly

4. Securely connect the connectors as

indicated in the table below.

NOTE:

• Check that the connector is facing the

correct way, and then insert it firmly

until it locks into place.

• Secure the cables with cable ties and

cord clamps, while being careful not to

pull on the connector.

* Be sure to make the ground connection.

(Refer to "4-14. Connecting the ground".)

Connector

Connection location on

main P.C. board

Cord clamp

X pulse motor encoder 5-pin white P20 (X-ENC) (3)

Y pulse motor encoder 5-pin blue P4 (Y-ENC) (3)

Intermittent presser foot pulse motor encoder 5-pin black P5 (P-ENC) (3)

Foot switch 10-pin P6 (FOOT) (3)

Operation panel 8-pin P1 (PANEL) (3)

Safety switch 3-pin P9 (HEAD-SW) (4)

Home position sensor assembly 12-pin P8 (SENSOR1) (4)

STOP switch 6-pin P13 (HEAD) (4)

Valve harness 12-pin P12 (AIR1) (4)

Programmer relay harness 8-pin P7 (PRG) (3)

Fan 6-pin P10 (SENSOR2) (4)

(Continued on next page)

3978M

Lock the cord

clamp securely.

3977

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Comments to this Manuals

No comments

Brother BAS-342G Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Sewing machines Brother BAS-342G