Brother BAS-342G Instruction Manual download pdf (Page 16)

4. INSTALLATION

BAS-342G

2. After placing the machine head onto the table, remove the

bolt (6) and the spacer (7).

The bolt (6) and the spacer (7) are necessary for

securing the support lever (8) when the machine head is

removed from the table, so keep them in a safe place.

3. Pass the support lever shaft (9) through the hole in the

support lever base (10) and through the groove (f) in the

support lever (8), and push it in until it is flush with the

surface of the support lever base (10).

* If it is difficult to pass the support lever shaft (9) through

the groove (f) in the support lever (8), move the end of

the support lever (8) up and down while passing the

support lever shaft (9) through.

4-5. Tilting back and returning the machine head

CAUTION

Hold the machine head with both hands when tilting it back or returning it to its original position.

In addition, do not subject the machine head to extra force while it is tilted back. If this is not observed, the machine head

may become unbalanced and fall down, and serious injury or damage to the sewing machine may result.

Always be sure to engage the stopper of the support lever (1) when tilting back the machine head.

If the stopper is not engaged, the machine head may return to its original position and your hands may get caught and

injury may result.

When disengaging the stopper, hold it by the knob (a).

If you hold at the place indicated by (b), your hand will get caught between the support lever (1) and the table when the

machine head is returned to its original position and injury will result.

The machine head can be tilted

back and returned to one of three

heights.

3966

Flush

3967

Disengaging

the stopper

Engaging

the stopper

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 83 84

No comments

Brother BAS-342G Instruction Manual Page 16