Brother BAS-342G Instruction Manual download pdf (Page 26)

4. INSTALLATION

BAS-342G

4-18. Lubrication [13]

CAUTION

Do not connect the power cord until lubrication is complete.

If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.

Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get into

your eyes or onto your skin. If the oil and grease get into your eyes or onto your skin, inflammation can result.

Furthermore, do not drink or eat the lubricating oil or grease. They may cause diarrhea or vomiting.

Keep the oil out of the reach of children.

• The sewing machine should always be lubricated and the oil

supply replenished before it is used for the first time, and

also after long periods of non-use.

• Use only the lubricating oil <Nippon Oil Corporation Sewing

Lube 10N; VG10> specified by Brother.

* If this type of lubricating oil is difficult to obtain, the recommended

oil to use is <Exxon Mobil Essotex SM10; VG10>

1. Fill the arm oil tank and the bed oil tank with oil.

NOTE:

Be sure to add more oil when the oil level drops down

to about one-third full in the oil gauge window (1). If the

oil drops below the one-third full level in the oil gauge

window (1), there is the danger that the sewing

machine may seize during operation.

2. Pour oil in through the two holes (2) of the shuttle race base

assembly so that the felt is lightly moistened.

NOTE:

If there is no more oil on the felt of the shuttle race base

assembly, problems with sewing may result.

3. If using the needle cooler (3), fill it with silicon oil (100

/s).

(Refer to "5-3. Threading the upper thread" for details on

using the needle cooler (3).)

3984

3985

3986

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 83 84

No comments

Brother BAS-342G Instruction Manual Page 26