LH4-B800E
4 - 9
4. Adjustment
e
w
q
r
r
e
q
q
w
4.5 0.5 mm
4-9. Adjusting the work clamp lateral position
1. Loosen the set screw q, and then move the feed arm w and the roller e to adjust so that the knife groove comes
to the center of the work clamp window.
* After adjusting, operate the presser foot lifter pedal and check that the work clamp moves up and own smoothly.
* After adjusting, check the upper thread trimmer mechanism and adjust if necessary.
4-10. Adjusting the knife home position sensor position
1. Loosen the screw q, and then adjust the knife sensor assembly r so that there is a clearance of 4.5 ± 0.5 mm
between the side of the sensor w and the edge of the solenoid stopper e.
Comments to this Manuals