LH4-B800E
3 - 18
3. ASSEMBLY
Install the crank rod guide q with the two bolts w and the screw e.
Install the needle bar bracket slide block r to the thread take-up lever set t. Pass the wick o through the support
shaft hole in the arm. Insert the washer y into the thread take-up lever set t, and then install it to the thread take-up
crank u. Insert the needle bar bracket slide block r into the groove in the crank rod guide q. Secure the thread take-
up lever set t by tightening the two set screws i.
Insert the support shaft !0 and secure it by tightening the set screw !1 so that the thread take-up moves smoothly with
no play.
3-10. Needle bar and thread take-up mechanism
t
r
e
q
y
w
!0
o
i
u
!1
q
(Screw stop side)
Comments to this Manuals