Brother LH4-B800E Service Manual download pdf (Page 113)

LH4-B800E

4 - 26

4. Adjustment

F = 98 N (10 kgf)

4-19. Adjusting the upper thread feeding amount

1. Loosen the screw q, and then turn the tension take-up lever w to adjust the upper thread feeding amount.

* Move the trimmer driving arm by hand and check that upper thread feeding is completed before the upper thread

is cut. If the above adjustment is not made, it may result in the upper thread pulling out or in upper thread clamping

errors.

4-20. Adjusting the feed timing belt

1. Remove the adjustment bolt q.

2. Loosen the three screws w so that the feed pulse motor e moves easily.

3. While using a spring gauge to push the notch in the motor mounting bracket r with a force of 98 N, tighten the

screws w.

4. Check that the timing belt t moves smoothly.

5. Gently tighten the adjustment bolt q.

If you do not have a spring gauge, loosen the three screws w and adjust using the adjustment bolt q. Adjust the

tension so that the amount of belt deflection is approximately 3.5 mm when a force of 5 N is applied in the middle of the

belt span.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 167 168

No comments

Brother LH4-B800E Service Manual Page 113