Brother LH4-B800E Service Manual download pdf (Page 40)

LH4-B800E

2 - 15

2. DISASSEMBLY

Loosen the bolt y.

Take out the solenoid plunger from the cutter solenoid w.

Remove the four screws r, and then remove the cutter solenoid bracket t.

Loosen the set screw @5.

Loosen the two set screws @6, and then remove the cutter driving arm shaft @7, from the set screw collar @8 and the

cutter driving arm assembly @2.

Remove the four screws @3, and then remove the cutter bar guide @4.

Remove the cutter driving arm assembly @2 from the arm.

Remove the cutter driving link !9, needle bar bracket slide block @0 and driving shaft holder assembly @1 from the

cutter driving arm assembly @2.

Remove the washer i and retaining ring E6 o, and then remove the cutter link bracket assembly !0 from the cutter

link shaft !1.

Remove the three bolts !4, and then remove the cutter solenoid w from the cutter solenoid bracket t.

Remove the spring washer !5 and the two nuts !6, and then remove the solenoid stopper !7 from the solenoid flange.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 167 168

No comments

Brother LH4-B800E Service Manual Page 40