LH4-B800E
3 - 23
3. ASSEMBLY
Provisionally install the thread guide w to the thread breakage perceiving shaft q with the plain washer e, plain
washer r and screw t, and then insert the thread breakage perceiving shaft q into the arm.
Provisionally install the thread breakage sensor assembly y with the two screws u.
Secure the cutter bar fixing plate i to the thread breakage perceiving shaft q with the set screw o.
Install the balancer !0 to the cutter bar fixing plate i with the screw !1.
Install the lever stopper !2 at the correct angle with the screw !3. Provisionally install the lever stopper !4 with the
screw !5.
3-13. Thread breakage detection mechanism
t
r
e
w
q
q
!0
o
i
i
u
y
!1
i
u
!5
!4
!3
!2
1 mm
Comments to this Manuals