Brother BES-1260BC Service Manual download pdf (Page 23)

BES-960BC.1260BC

Chapter 2 Parts Replacement and Adjustment

[Reassembling the head]

1. Hook the head q on the projections of the bridge w, make contact with the right side of the head to the spring pin e,

and attach the head

q to the bridge w with the three bolts r.

2. As shown in the figure, insert the driving shaft t from the left while passing it through the inner presser collar i, the

thrust roller bearing o, and the two thrust washers !0 so that the zero bight needle location dog y and the photo-sensor

u do not make contact with each other.

Insert the driving shaft

t all the way until the visor of the bearing !2 makes contact with the end of the driving shaft

bearing !3.

3. Press pulley B

!1 so that it covers the driving shaft bearing !3 with the inner presser collar i, and tighten the set screw

of the inner presser collar

i to eliminate end play.

visor

1 ... 22 23 24 ... 198

No comments

Brother BES-1260BC Service Manual Page 23