Brother BES-1260BC Service Manual download pdf (Page 45)

BES-960BC.1260BC

Chapter 2 Parts Replacement and Adjustment

STOP

START

10.Check that there is no error being displayed on the op-

eration panel. Then, while pressing the STOP key, press

the ( ) jog key. “tcut” will then appear on the display.

11.Press the ( ) jog key so that “CASE” appears ont he display,

and then press the START key. The display will now show

“xxx1”.

12.Turn the potentiometer

!1 all the way to the left as shown

in the illustration at left. When it is then turned gently to

the right, there will be a point where the buzzer on the

operation panel sounds.

• The point where the buzzer sounds is the potentiometer

!1 position for the first stitch. The display will appear as

shown in the illustration at left at this time.

13.While the buzzer is sounding, install the potentiometer

!1 to the change box by following the removal procedure

in reverse.

Note:

• Keep checking the buzzer to make sure that the po-

tentiometer

!1 does not move out of its adjusted po-

sition.

• Be careful not to move the needle position which was

adjusted in step

o either.

14.Once the potentiometer has been installed, press the

needle bar change key on the operation panel to move

the needle bar to needles 1 to 9 (BES-960BC) or needles

1 to 12 (BES-1260BC) in order to check the operation.

15.After carrying out the above checking operation, install

the color change cover

1 ... 44 45 46 ... 198

No comments

Brother BES-1260BC Service Manual Page 45